24-hour sales and car purchase consultation hotline: 15335795555( 秦部长 Minister Qin)     中文
Hello!Welcome to visit Chengli special purpose vehicle Co., Ltd. sales 24 branch.

What are the requirements for the installation and pasting of reflective signs on fire fighting body

Time:2022-04-19       return technical information list

Reflective signs shall be set on the side and rear of the fire truck. When installing reflective signs, the following requirements shall be met: the reflective signs of the vehicle body shall be installed or pasted on the rear and side outer surfaces of the vehicle body that are unobstructed and easy to see; Different types or grades of vehicle body reflective signs can be installed or pasted on the rear and side of the vehicle body, but the same type or grade of vehicle body reflective signs shall be selected for the rear and side of the fire truck; When installing or pasting, the reflective signs on the rear and side of the vehicle body shall start with the white unit and end with the white unit; After the vehicle is installed or pasted with reflective signs on the vehicle body, the performance of other lighting and signal devices of the vehicle shall not be affected; After the vehicle is installed or pasted with the body reflective mark, it is not allowed to drill holes or slots on the body reflective mark. The pasting position of reflective signs at the rear and side of the fire truck body is shown in Figure 13-15.

The height of the reflective sign at the rear of the fire truck body from the ground shall not be less than 380 mm. When the primary reflective film is adopted, the sum of its area and that of the rear reflector shall not be less than 0 l m ’; When the secondary reflective film is adopted, the sum of its area and the rear reflector shall not be less than 0.2 M. the pasting of reflective signs is allowed to be interrupted, but the length of each continuous section shall not be less than 300 mm, and at least one unit of red and white body reflective signs shall be included. Under special circumstances, red and white units are allowed to be pasted separately, but red and white shall be kept alternately, and the length of each continuous section shall not be less than 150 mm. Under the condition that the structure allows, the reflective signs on the rear body shall be symmetrically distributed on the left and right, and reflect the rear width and contour of the vehicle as much as possible. The total length of horizontal installation or pasting (excluding the spacing part) shall not be less than 80% of the rear width of the vehicle; The reflective signs on the side body of the fire truck shall be installed or pasted continuously as far as possible. When intermittent installation or pasting is adopted, the total length (excluding the interval part) shall not be less than 50% of the vehicle length. The reflective mark shall be pasted on the protective device or the fixed components of the vehicle body as far as possible, and the reflective film shall be pasted on the flat surface of the vehicle body. The pasted part shall be cleaned before pasting, and the edge of the reflective film shall be waterproof and dustproof after pasting.

Recommended products

  • Reference price 15335795555
  • Reference price 15335795555
  • Reference price 15335795555
  • Reference price 15335795555
  • Reference price 15335795555
  • Reference price 15335795555
  • Reference price 15335795555
  • Reference price 15335795555
  • Reference price 15335795555
  • Reference price 15335795555
15335795555 (Wechat)